Setting Device Group
Group ID's are the way to limit communication between multiple sets of Sender/Display sets. Devices will only communicate with other devices that have the same Group ID number. Senders and Displays have a default Group ID set to 1. If you have multiple sets and do not want them to talk to each other, set a different ID on each set.
Option 1 - Use the display
The remote display can set Group ID's on connected nodes and is a simpler method. Refer to the display guide on setting Device Group ID's for more information.
Option 2 - Use the hardware button
Accessing internal controls
Unscrew the sensor cords and pull straight out to remove them. Remove the nuts on the sensor connectors using a 11mm socket.
Remove the black endcap by unscrewing the 4 screws. Screws are self-retaining in the endcap so loosen one halfway until you feel resistance then move to the next. Continue until they are fully removed.
Slide the circuit board out 1/2” to see the dip switch at the left.
Click the MAX button to increase the Group ID number by 1. The status light will flash yellow the number of the group. For example, pressing once will change to group 2 and the light will flash two times.
Once you reach group 8, it will restart back at group 1.
Press and hold the MAX button for 1 sec to save your changes.
Release the button when the status light flashes green to confirm it is saved.
