Setting radio range
Senders ship with the range set at normal which is 800' with out obstructions impeding the signal. It can be increased for special case scenarios that need additional distance.
Option 1 - Use the display
The remote display can set radio range on connected nodes and is a simpler method. Refer to the display guide on setting radio range for more information.
Option 2 - Use the hardware button
Click the ZERO button to increase to the next higher level setting. The status light will flash yellow to indicate the range setting you are on (one flash = level 1, two flash = level 2, ...). Once you reach the highest level setting the next press will be back to the start at normal.
Press and hold the MAX button for 1 sec to save your changes.
Release the button when the status light flashes green to confirm it is saved.
Range levels:
800' line of sight, transmits 3x/sec
1400' line of sight (or 1000' through 16 houses), transmits 2/x sec
2000' line of sight, transmits 1x every 2sec
3000' line of sight, transmits 1x every 3sec
Important Note: Display unit and sender MUST have the same setting to communicate